The Cob-8Mm-1584 Truck Bed Light Strip Comes In A 2-Pack Set. The Product Includes Two 60-Inch Flexible Led Truck Bed Light Strips With Adhesive Backsides. It Also Has An Extension Cable With A Waterproof On/Off Switch Splitter And 5A Standard Inline cutting edge Fuse Holder. Additionally It Comes With Led Strip Fixing Clips Stainless Steel Screws Plastic Cable Clamps Zip Ties And Heat Shrink Tubes.

The Specs Of This Product Are As Follows: Operates At Dc 12V Voltage And Has A Power Of 30W. The Pcb Width Is 8Mm And It Has 1584 Chips. The Color Rendering Index (Ra) Is Greater Than 90 And The Color Temperature Is White At 6500K. It Has A Water Resistance Level Of Ip67.

For Installation First Wipe Down The Truck Bed To Remove Contaminants For Proper Adhesion. Tear Off The Adhesive Tapes Peel On The Back Of The Module And Position The Lights Along The Truck Bed Walls Pressing Firmly. Adjust For The Best Illumination. Then Connect The Light Bars To The Extension Cable.

Connect The Red And Yellow Wires In The Extension Wire Bundle To The Power Source (Red To Positive Yellow To Negative). Run The Power Wire Through An Existing Hole In The Firewall To Reach The Battery. It Is Recommended To Get Power From The Car Battery. When Drilling Holes In The Firewall Use A Rubber Grommet.

After Installation Test The Lights With The Switch And Insulate The Wires. The General Installation Steps Include Preparing Tools And Materials Cleaning The Installation Area Determining The Installation Position Installing The Light Strips By Tearing Off The Adhesive Film And Pressing Firmly Connecting The Wires (Extension Cable And Power Supply) Passing Through The Firewall Connecting To The Battery With A Fuse Holder For Protection Testing The Lights And Organizing The Wires.

The White Light Of These Truck Bed Light Strips Provides Good Illumination And Can Enhance Visibility In The Truck Bed Area.