Why need a channel with diffuser

• Protect the exposed strip from Dust, Moisture and inadvertent touch, extend the lifespan of the strip
• Provide a New Professional Clean finish to the exposed fixtures, Take your LED strips to the next level
• breake up the harshness dots from the led strip without making light too dim, evening out the lights to a fairly smooth glow. Steps for a DIY Lighting Project 1.Measure the width of the strip (make sure it is not oversized in the channel) and test it 2.Trim the channel and cover to a required length by hacksaw or other devices. 3.Peel off the sticky at the back of the strip, lay the strip in the channel
• Snap the diffuser into the slot of the V channel, fix the end caps if needed
• Screw the Mounting Clips into the working surface (Make sure the Pilot hole is in a straight Line), Clamp the channel in the clips
• Flush channel end to end and fix clips in the middle of the channel for extension
• Wiring The Strip Can be assembled after mounting the channel or away from the working site Packing details 1.3.28FT/100CM V Shape Aluminum Channel -10 pieces 2.3.28FT/100CM Milky Cover -10 Pieces 3.304 Stainless Steel Countersunk Screw -30 Pieces 4.End Cap With Hole -10 Pieces 5.End Cap Without Hole-10 Pieces 6.Stainless steel Mounting Clips-30 Pieces 7.90 Degree Corner Connector X2