Our boat trailer light set is designed to keep your trailer lights out of the water by easily mounting on your guide posts and poles. Saltwater tested IP67 Rated Lights that are DOT SAE Approved for trailer use. Our lights have evening running light capability and turn and brake capability.

Our lights feature upgraded marine tinned copper wire that will not quickly degrade like the majority of wire on the market. Designed to fit on 2inch PVC guide posts with a 2.36 inch opening in the base. Our two light set comes with everything you need to install. Stainless screws heat shrink butt connectors and wire ties to seHelps Support any excess wire.

• Federal regulations require that trailer lights be no higher than 72 off the ground. Remove existing cap or cut if glued on. Double check and cut to achieve a light height that is appropriate.
• Test fit light then fish the three wires down the existing pole. There are three color wires on each light (White Black Red).
• Follow: A- WHITE WIRE = Ground Wire commonly connected to the trailer frame. Use included stainless screws if needed. B- BLACK WIRE = Tail / Running Lights (On most trailers if using existing wiring connect to brown color wire. C- RED WIRE = Brake Stop + Turn Signal (Driver / Left side connect to YELLOW) (Passenger / Right side connect to GREEN) IP67 Rating - Sealed entry designed to withstand saltwater spray and moisture Voltage: 9-13.5vDC
• PER EACH LIGHT = Current Draw (.19A@12.5V)
• Watts: 2.3 Watts at 12.5V Dimensions: 11 Height 3 maximum width Wire Length: 10 Approx
• Designed for 2 PVC Poles (2-3/8 OD) LED Lights meet DOT/SAE/STI 16 Standards Marine Grade Tinned Wire
• Stainless Mounting Screws Included
• Blue Heat Shrink Connectors Included
• Tie Wraps Included For Wires